taultunleashed

Ok so when I launch xunleashed and it opens EQ2 and it begins to run when I open the macro window. I can't click on record or change any of the options on the macro window. I had it actually run once with no problems. I did notice that if I click on the record button or play button over and over again I can get to to start recording and can even get the macro to start playing but I cannot change any of the other options i.e loop macro ect. So basically say I record a crafting macro after spamming record a bunch of times. I can't click and get the X to stay next to loop macro. I can however spam play and it will play and work correctly. right now I'm at work I'll post the log file later tonight but I don't believe anything was goign wrong.

Any help would be apperciated!!!

This is explained in the Spice macro thread, but I'll tell it here.

Press P and put your Persona window BEHIND your macro window.

Then you can use your macro window normally.

TY I thought I was doing it right to begin with but I was closing the persona window... after I could move the box to the right