EQ2Crafter v2.5 (EQ2 plugin to craft with counter buffs) : EverQuest 2 Premium Discussions

What is going to happen to EQ2 crafter when LU19 goes live? No more subcombines, redesigned UI window. Is this something you guys are already working on an update for?

Sorry if this has already been covered. I was using EQCrafter up till about 2 weeks ago but haven't been able to "update plugin" since then within tault. I found i needed to do that each time prior to using it otherwise it wouldnt work properly. Anyway, now I just get an error message when I try to update the plugin prior to launching EQ2 and the program won't work at all.

Any ideas? Thanks.

Well LU19 has messed up the crafter a little also, i can get about 3 combine's then the mouse starts moving back and fourth and it stops casting reactive's

Its being worked on.

Since LU 19 my crafter bot is not working properly:
the repeat and begin buttons are not pushed at all
Reactives work fine, I can do as many combines as I like, manual!

?maybe the new crafter window design? it seems the mouse pointer is about a quarter inch above the buttons

Hope this gets fixed soon!
Keep up the good work guys

quote="jacob428"]

ekuth1 wrote:It looks like they resized the UI windows for crafting, adding a 4th item component box. This throws off the spacing between the fuel box and the craft/repeat button below it.

Just in case you didn't figure this out yet. When you are configuring it, if you place the top line of the yellow box at the bottom line of the fuel box and line them up, it will work properly.[/quote]

Plus verify that the hotbar you use for buffs is your primary

Thanks for the notice. I'll update the plugin to have the new position correctly shown, but yea reantrezz is correct, that will work until I can get ou t a patch!!!

The bot seems to work normally for about 15 minutes, then will stop and an error message, something to the effect of:

Runtime error 11

'Division by zero'

is displayed.

Then the eq2 client crashes.

Try windowed.

Are you on a AMD processor?

Do you have the eq2 radar installed?

Wyvernx things are working great and as usual you are on top of things for us. Only thing missing is the ability to save settings for WOODCRAFT, BINDING, GEOCRAFT, THAUMATURGY the 4 alternate trade skills. Once those are there someone like me can do all 9 primary trades plus the alternates.

I'm devoting the time into the XUM version of the plugin. Since it will have pretty much full sources, I'm hoping that you and others can take it and make it something grand!!!

Disregard my previous message. Looks like a temp fix for using this is well in hand. Good job for figuring out the obvious. Some days I wonder about myself... Also nice to see this excellent macro being supported. It might be useful to put in some user defined offsets to counter any future changes like this that might occur so the macro doesn't have to be re-written everytime SOE makes a UI change. Just a suggestion.

wyvernx wrote:Try windowed.

Are you on a AMD processor?

Do you have the eq2 radar installed?

Thanks for the reply, and:

I always run windowed

athlon 64 3200+

and no I do not have eq2 radar installed, does this mean I need to install it, or were you asking because it causes problems?

symonger, it might be a win64 issue if you are running win64. win64 is not supported fully yet.