How To: VGExtreme Service : VGExtreme General Discussion

did they get the vg viper finished?

For the bots currently here in this forum, my crafting bot is still maintained and can run fully automated for hours. The diplo bot could work again (and is quite good) if a couple offsets are fixed in the service. Some of the other smaller bots may work if tweaked, although none of those have been maintained.

I tried MMOviper, the free one. And it sucked, the patrol routes don't work and the fighting combos don't work.

Is it the free one you say im gonna get soon or is there a more advanced one that costs money?

mmoviper will soon be tied into TU premium memberships, meaning the monthy fee bots will be included in your membership here.

I have not tried the vg viper bot. personally, I never used adventuring bots much except for buffbots/assist bots. However, I did play around with it on warhammer and it seemed to work fine. There is quite a bit of configuration to get it running the way you like, however, and that is likely the story behind your grief. (a good amount of code is recycled between the different viper game bots)

My advice is... explain your problem with patrol routes and combos in detail on the mmoviper forums, and someone will be able to give you some useful help. More often than not, the problem is in configuration.

The viperbot is free to use right now for everyone. Go on over and try it out.

www.mmoviper.com

The link to windows debugger seems to be dead. Is there anywhere else I can download it?

twitchsa wrote:The link to windows debugger seems to be dead. Is there anywhere else I can download it?

There's one attached to a post by wyvernx in this thread:

http://www.taultunleashed.com/phpbb2/about26860_Download_and_use_of_the_Exhume_Stand_Alone_Client.html

BTW, a quick search of the forums found it. Search is your friend.

I've pretty much stopped support for it, as I'm working on the new VG bot on mmoviper which is free for all tu members.

Clicky on on the link and it just comes up with "page load error" . any help?

Try again... I was just able to successfully click on both the thread link and the link to the debugger.

I'm running windows 7 and the program just crashes, what am I doing wrong?